28 lines
1.1 KiB
Markdown
28 lines
1.1 KiB
Markdown
# Welcome
|
|
|
|
### This project is a Door access system built on RPIs
|
|
|
|
#### Getting Started
|
|
|
|
1) Start by installing the latest version of raspianOS on your Raspberry Pi
|
|
1) Get Raspberry Pi Imager from the web
|
|
2) Launch it
|
|
3) Choose your model
|
|
4) Choose OS (Raspberry PI OS 64-bit)
|
|
5) Select your SD card
|
|
6) Press Ctrl+Shift+X
|
|
7) Set a hostname
|
|
8) Set a username and password
|
|
9) Set locale settings
|
|
10) Press Save
|
|
11) Press the "Next" button
|
|
12) Continue through any further prompts, keeping all settings that were set
|
|
2) Boot the Raspberry Pi
|
|
3) Open a command prompt on a seperate computer
|
|
4) Ping the hostname set in 1.vii to find the IPv4 address (might need `-4` flag)
|
|
5) SSH into the RPI (Raspberry Pi)
|
|
6) run `git clone https://gitea.eggtech.net/eggman20339/CNSA-276-FP.git && sudo chmod 777 CNSA-276-FP/install.sh && ./CNSA-276-FP/install.sh`
|
|
7) The script should take care of the rest, the RPI will restart and then auto start the program
|
|
8) after reboot, to edit the config, SSH back in and navigate to `/CNSA/CNSA-276-FP/`
|
|
9) run `nano config.ini`
|
|
10) alter any config needed |